3er-pack 433,92 Mhz Festcode-fernbedienung, Schlüsselanhänger-rf-sender (nur Für Festcode, Nicht Für Buchstabencode)

【Superior Design】433MHz RF Fixed Code Remote Control Cloner. This is a copier capable of cloning other fixed code remote controls. It boasts a strong signal that penetrates walls, floors, doors, wooden boards, and other obstacles. In open areas, the remote control distance can reach up to 50 meters. 【Wide Encoding Range】Compatible chips for copying: 2260 (all manufacturers), 2262 (all manufacturers), PT2264, 5326 (all manufacturers), SC5262, HT600, HT680, HT6207, HT6010, HT6012, HT6014, SMC918 series, 527 (all manufacturers), 1527 (all manufacturers), 2240 (all manufacturers), HCS101, HCS200/HCS201 (partial codes), HCS300/HCS301 (partial codes), and some microcontrollers. ***Note: Rolling code remote controls cannot be used!!! This product can only copy fixed codes. 【Pre-purchase Notes】Please confirm the following three conditions before purchasing: ① The original remote control is working properly; ② The frequency is 433.92MHz; ③ The chip code (encoding chip) matches the list; ④***Note: Rolling code remote controls cannot be used!!! This product can only copy fixed codes. 【More Flexible】The remote control has 4 buttons, meaning you can copy 4 buttons. Each button operates independently. The copied remote control can be reset and set an unlimited number of times. 【Wide Applications】This product can be used in homes, farms, factories, offices, laboratories, supermarkets, etc. You can use the copied remote control to clone various remote controls, such as garage doors, electric doors, roller shutters, retractable doors, electric curtains, fans, lamps, lighting equipment, ventilation equipment, signal transmission equipment, etc. Clearing Code Method: Press and hold the lock and unlock buttons simultaneously (some casings have up and down buttons). The LED indicator will flash three times. Release one of the pressed buttons, but without releasing the other, press the released button three times. The LED indicator will then flash rapidly. At this point, all data in the memory has been cleared. After clearing the data, the LED indicator will not light up regardless of which button is pressed on the remote control. Copying Method: Hold the original remote control in one hand and the copying remote control in the other. Keep both remote controls as close together as possible (ideally, place them side-by-side on a table with almost no distance between them). Press the desired copying button on each remote control. The LED indicator will flash three times quickly, then flash rapidly again, indicating successful copying. Repeat the same process for other buttons. Some remote controls have lower transmission power; in these cases, the original and copying remote controls should be placed back-to-back for better copying results. Avoid environments with interference. If copying is unsuccessful, clear the code and try again. (Very Important: Your remote control must be working properly and operate at the same frequency as our remote control.)